mbacollegespune.in













Monday, 17 June 2013

SOLUTION FOR Lumia 710 / 800 / 800C "NOT FLASHING" after TP BOOT REPAIR


The
solution described below is for phones with "un-alligned" or corrupted
AMSS + ADSP Region caused by improper custom firmware flashing or by
other means of data corruption.




Here is sample logs showing the error during Normal USB Flashing:


================================================== ======
Sending OSBL Certificate HASH: C72DBA3ABED42215584093FA9DE247381D6062B4

Certificate Size: 452 Bytes

ERROR: Data Rejected at SEQ 0x3

Status : WRITE OSBL CERTIFICATE FAILED
==============================================



STEP 1:

In order to fix this problem, you first need to write QUALCOMM OSBL to your phone via TP Method.

Select Correct Phone Type and make sure
M.B.R. + SEC_BOOT + OSBL QCOM is selected as well. Then click REPAIR BOOT!!!





STEP 2:
Remove USB Cable and press and hold POWER BUTTON for 18 Seconds. Then press and hold VOLUME UP Button while connecting the USB Cable to the phone.


*** Your Phone should now be detected as a New HDD Device and Windows will ask you to FORMAT IT... Of course




DO NOT FORMAT



STEP 3:
Download the proper RAW BOOT Files for your phone.


Lumia 710 RM-803 and RM-809
Lumia 800 RM-801 and RM-819
Lumia 800C RM-802



STEP 4:
Go to eMMC Direct tab in ATF Software and click "Scan Partitions". If your phone is NOT DETECTED, go back to STEP 2. Repeat Step 2 until your phone is DETECTED Properly.


After ATF Software successfully Lists the Partitions Found on the Phone, click "Backup Phone Data" so you will save your IMEI, Simlocks and other important data safely.





STEP 5:
Now Let us write Boot Files which you downloaded from Step 3.
Extract the RAR file and then write the 3 RAW Boot Files 1 by 1:

5a. dbl_RM-XXX.bin <--- Write this to 0x4D - DBL Partition

5b. osbl_nokia
_RM-XXX.bin <--- Write this to 0x46 - OSBL Partition
5c. amss_adsp
_RM-XXX.bin <--- Write this to 0x0C - AMSS_ADSP Partition




5a - DBL



5b - OSBL_NOKIA



5c - AMSS_ADSP



STEP 6:
Click "SP UNLOCK" if you want to unlock your phone after fixing the BOOTS.


Now YOU can flash the phone Normally with any Supported Firmware via Normal USB Flashing.




*** WARNING: Everytime you flash your phone with another firmware, you
will always RESET the SP Lock status and RESET the SP Lock Counters. To
avoid your phone from getting RE-LOCKED, always make sure to UN-CHECK the "XXXXXXX_prod_generic_amss.esco" flash file
before you click the FLASH Button. By Skipping this file, you can
always re-enter "00000000" to unlock your phone again after flashing.

Android Mobile Doctor

0 comments:

Post a Comment

 

Copyright @ 2013-2015 Android Mobile Doctor.