Phone is auto powered on with USB Data Cable connected to the PC while battery is connected.
Current resurrector works via USB interface thus no JTAG connection is
required. You may need to install RIFF BOX DCC Loader USB Interface USB
driver if you run this for the first time. Drivers are located in JTAG
Manager directory (Drivers folder).
In order to connect, device must be detected by system as Qualcomm
HS-USB QDLoader communication port. To force device into this mode (that
is if your device is dead but there is still no USB activity when you
connect it to PC with USB cable) use testpoint to disable the eMMC
memory – for this shortcut specified point on the schematics to the GND
during power-on stage.
Resurrector will reflash radio’s boot zones and will re-write PDA’s SPL
to 1.30.0000 version. Additionally to SPL and Radio zones, the zone
which contains Model ID is re-flashed too. Thus after resurrection phone
will have Model ID = ‘PH4430000’.
There is option to reflash BOOT and RECOVERY zones.
To resurrect HTC EvoDesign4G via USB Cable:
- If required, use testpoint to force HS-USB QDLoader mode: for this
de-power board, shortcut specified point in the schematics to GND with
the help of a needle, insert USB cable into PC, wait while phone
enumerates as HS-USB QDLoader and then remove the needle;
- Make sure USB cable is attached to the board and is connected to PC;
- Make sure HTC EvoDesign4G via USB is selected in the list of models;
- Click Resurrect button;
- Wait till software signals a successful operation completion;
- Disconnect power supply, de-solder JTAG wires;
Now phone is in bootable condition, that is, even if it does not
start up normally you can flash it using known flashing methods.
To enter download mode:
- Disconnect PC cable;
- Insert battery;
- Hold ‘Volume Down’ key and press ‘Power ON’ button.
