mbacollegespune.in













Wednesday, 24 April 2013

HTC Titan X310E (HTC Eternity) Unbrick, Unlock, IMEI and SuperCID repair supported Repairing bricked HTC Titan (PI3911000) is easy with the RIFF Box.



 Phone is auto powered on with USB Data Cable connected to the PC while
battery is connected. Please note, battery presense is required.


Some (or all) revisions of HTC Titan (PI3911000) boards have JTAG
interface disabled (that is enable MARM JTAG Fuse is blown in the MSM
chip). In this case the JTAG may be enabled only by firmware itself.
This is done by the DBL loader, so if DBL area is damanged and MCU has
JTAG Disable FUSE blown then there is no way to resurrect your phone via
JTAG interface. However, in this case you may use HTC Titan (PI3911000)
USB DLL version which does not require JTAG interface and does
resurrection procedure via USB cable.

Resurrector will reflash radio’s boot zone (except DBL area) and will
re-write PDA’s SPL. Additionally to SPL and Radio zones, the zone which
contains Model ID is re-flashed too. Thus after resurrection phone will
have Model ID = ‘PI3911000’.


To resurrect HTC Titan (PI3911000):


  •  Solder JTAG cable to HTC Titan (PI3911000) JTAG pads;

  •  Insert battery and connect USB Data cable;

  •  Make sure HTC Titan (PI3911000) is selected in the list of models;

  •  If you use only battery, press Power On key;

  •  Click Resurrect button;

  •  Wait till software signals a successful operation completion;

  •  Disconnect power supply, de-solder JTAG wires;



Now phone is in bootable condition, that is, even if it does not
start up normally you can flash it using known flashing methods.


To enter download mode:


  •  Disconnect PC cable;

  •  Insert battery;

  •  Hold ‘Volume Down’ key and press ‘Power ON’ button.



.

htc_titan_x310


Android Mobile Doctor

0 comments:

Post a Comment

 

Copyright @ 2013-2015 Android Mobile Doctor.